WILO Wilo Fluidcontrol Electronic Flow and Pressure Controller HiControl 1 – 4190896

Electronic control and regulating accessories. The Wilo-HiControl 1 series is used for clear water pumps to enable automatic operation. Wilo-HiControl 1 protects the pump from low flow operation. Thanks to a flow sensor and pressure sensor, Wilo-HiControl 1 automates the pump between two values, the cut-in pressure and the cut-off flow. If the pressure in the network is lower than the cut-in pressure, Wilo-HiControl 1 starts the pump. The pump operates until the flow rate falls below the cut-off flow rate. The internal, small tank prevents water hammer and cycling. Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible motor pumps for private water supply. FeaturesEasy installationDue to its particularly compact design, it is suitable for many applicationsHigh operational reliability thanks to electronic fault messagesProtection of connected pumps through integrated dry-running protectionEasy operation thanks to clear operating status display and pressure gaugeNo additional diaphragm pressure tank requiredPerfect corrosion protection thanks to stainless materialsInline design with inlet and outlet in vertical axis and uniform threaded connections, suitable for direct connection to the pump housing or for wall mounting using a wall bracket (accessory).NoteThe HiControl 1 may only be installed in a vertical position with the outlet at the top!Scope of deliveryHiControl 1Cable ties for quick and secure installation of plug-in pump unitsTechnical dataPhases: 1Rated voltage: 220/230/240 VMains frequency: 50, 60 HzMin. rated current: 2 AMax. rated current per pump: 10 AProtection class: IP65Min. medium temperature: 5 °CMax. medium temperature: 50 °CMin. ambient temperature: 5 °CMax. ambient temperature: 50 °CMax. flow rate: 8 m³/hInlet connection: G 1Outlet connection: G 1Housing material: PA6Net weight approx.: 1 kgBrand: WiloItem no.: 4190896