WILO Wilo DrainLift MINI5-XS/WC-EF Small Wastewater Lifting Unit, 230 V, 700 W – 6095130

Compact, ready-to-connect lifting unit with alarm contact, for draining washbasins, showers and WCs.Pumping mediumFor collecting and pumping in domestic areas of:Wastewater containing faecesWastewater pumping according to 12050The wastewater lifting unit meets the requirements of EN 12050-3.For systems according to 12050-3, observe the following points:All connected drainage fixtures are installed in the same room.Another toilet is available above the backflow level.DesignCompact, ready-to-connect and fully submersible lifting unit with a submersible motor pump. The submersible motor pump is equipped with a rotating cutter. The cutter reliably shreds faeces in the wastewater. Level detection is carried out with a level sensor. Ventilation is integrated in the intermediate floor and equipped with an activated carbon filter. In addition, the lifting unit is equipped with a buzzer and a potential-free alarm contact (max. switching capacity: 42 V=, 500 mA, contact type: normally closed (NC)). In the event of high water in the tank, an acoustic alarm is triggered by the buzzer. An external alarm can also be connected via the potential-free contact. The tank lid perfectly seals the unit.Up to five connections are available:1x inlet 40 mm (DN 40), without non-return valve, routed upwards, factory-sealed.2x inlets 40/50 mm (DN 40/50), with non-return valve, routed horizontally to the left and right, factory-open.1x toilet connection 110 mm (DN 110), routed to the front, factory-open. − If required, the WC connection can be routed horizontally to the left. The corresponding opening is factory-sealed.1x pressure connection 32/40 mm (DN 32/40), with non-return valve, routed upwards, factory-open. − If required, the pressure connection can be routed horizontally to the right. The corresponding opening is factory-sealed.Scope of delivery1x sleeve for HT pipe DN 32/40 (32/40 mm)2x hose clamps 32-50 mm1x sleeve for HT pipe DN 110 (110 mm)1x clamping ring1x hose clamp 110-130 mm2x inlet connections DN 50 (50 mm)2x sleeves for HT pipe DN 40/50 (40/50 mm)2x non-return valves2x pipe clamps 50-70 mm2x hose clamps 32-50 mm2x sealing plugs6x O-ringsFloor mounting (anti-buoyancy device): 2x mounting brackets with screws and plugsSet for emergency emptying (drainage hose, hose clamp, sealing plug)Set for deep suctionSet for horizontal pressure connectionInstallation and operating instructionsOperating dataPumping medium: Water, wastewater - without faeces, wastewater - faeces-containingPermissible application areaMedium temperature: 3 °CAmbient temperature: 3 °CMaximum operating pressure: 0.9 barMax. switching volume: 2.7 lMotor dataMains connection: 1~230 V, 50 HzVoltage tolerance: ±10 %Rated motor power: 420 WRated speed: 2800 rpmRated current: 3.4 AInsulation class: FMotor protection class: IP68Max. switching frequency: 20 MaterialsTank: ABSPump housing: PP-GF20Impeller: PP-GF20Installation dimensionsSuction-side pipe connection: DN/OD 40 (HT pipe), DN/OD 50 (HT pipe)Pressure-side pipe connection: DN/OD 32 (HT pipe), DN/OD 40 (HT pipe)Order informationMake: WiloNet weight approx.: 8 kgArticle number: 6095130