ELTAKO Staircase Time Switch, 230V. 1 NO contact, not isolated, 10A/250V AC – 61100102

1 NO contact, non-floating 10A/250V AC, 230V LED lamps up to 600W, CFL up to 200W, incandescent lamps up to 2000W. Switch-off pre-warning and push-button continuous light can be switched on. Stand-by loss only 0.7 watts. With CFL optimization. For flush mounting. 45mm long, 45mm wide, 18mm deep. Contact switching at zero crossing to protect contacts and lamps. Due to the use of a bistable relay, there is no coil power loss or heating when switched on. After installation, wait for the automatic short synchronization before connecting the switched load to the mains. Control, supply and switching voltage 230V. Time setting 1 to 12 minutes. Glim lamp current up to 50mA, depending on the ignition voltage of the glim lamps. For 3- and 4-wire circuits, retriggerable, with attic lighting in 4-wire circuit. Automatic detection of circuit type. After a power failure, the lighting is switched on again if the timer has not yet expired. If the switch-off pre-warning is activated, the lighting flickers for approx. 30 seconds before the timer expires and a total of 3 times at shortening intervals. If the push-button continuous light is activated, pressing the button for more than 1 second will switch to continuous light, which is automatically switched off after 60 minutes or can be switched off by pressing the button for more than 2 seconds. If both push-button continuous light and switch-off pre-warning are activated, the switch-off pre-warning occurs after the continuous light is switched off. If energy-saving lamps (CFLs) are switched, either entirely or partially, set the switch-off pre-warning with push-button continuous light CFL on the lower rotary switch. Within the first second after switching on or retriggering, the time in the TLZ functions can be extended by pressing the button briefly up to 3 times (pumping). Each press adds the set time once. Can be switched to ESV function, impulse switch with delayed fall-back up to 120 minutes. In this function, the device switches off automatically after the set delay time has elapsed if the manual off command has not been given. If the delay time is set to minimum in the ESV function, the delayed fall-back is deactivated and the normal impulse switch function ES results.