ELTAKO RS485 Bus Actuator 2-Channel Latching Relay – 30014002

Impulse switch relay with 2 channels, 1+1 normally open contacts, potential-free 16A/250V AC, 230V LED lamps up to 400W, incandescent lamps 2000W, with DX technology. Bidirectional. Stand-by loss only 0.1 Watt. Modular device for mounting on DIN-EN 60715 TH35 mounting rail. 1 module = 18mm wide, 58mm deep. Connection to the ELTAKO-RS485 bus. Cross-wiring bus and power supply with jumper. With the patented ELTAKO-Duplex technology, the normally potential-free contacts can switch at zero crossing when switching 230V AC 50Hz, thereby drastically reducing wear. To do this, simply connect the N conductor to terminal (N1) and L to 1(L) and/or N to (N2) and L to 3(L). This results in an additional stand-by loss of only 0.1 Watt. In the event of a power supply failure, the switching state is maintained. When the power supply returns, it switches off in a defined manner. The channels can be taught in independently as ES and/or ER channels. Scene control: With one of the four control signals of a rocker switch taught in as a scene push button, several channels of one or more FSR14-2x can be switched on or off for each scene. Central commands can be sent with wireless push buttons and/or with a controller. The rotary switches are used to teach in the push buttons and, if necessary, test the 2 channels. For normal operation, the middle and lower rotary switches are then set to AUTO. The upper rotary switch can be used to set the EW time (0-120 seconds) for relays or the RV time (0-120 minutes) for impulse switches equally for all channels. If wireless motion brightness sensors FBH (Master) and/or FBH (Slave) are taught in, the upper rotary switch is used to set the switching threshold, for each channel separately, at which the lighting switches on or off. Settings of the upper rotary switch according to the operating instructions. If wireless brightness sensors are taught in, the upper rotary switch is used to set the switching threshold, for each channel separately, at which the lighting switches on or off depending on the brightness (from approx. 0 lux in position 0 to approx. 50 lux in position 120). A hysteresis of approx. 300 lux between switching on and off is fixed. An additionally set RV time is not taken into account. Only one FBH (Master) or FAH can be taught in per channel. However, one FBH (Master) or FAH can be taught in multiple channels. If wireless window-door contacts FTK or window handle sensor FFG7B are taught in, different functions can be set with the middle rotary switch in positions AUTO 1 to AUTO 4 and a maximum of 116 FTKs can be linked: AUTO 1 = window closed, then output active. AUTO 2 = window open, then output active. In positions AUTO 3 and AUTO 4, the FTKs taught in on one channel are automatically linked. With AUTO 3, all FTKs must be closed for the normally open contact to close (e.g. for climate control). With AUTO 4, one open FTK is sufficient to close the normally open contact (e.g. for an alarm message or switching on the power supply of an extractor hood). One or more FTKs can be taught in multiple channels so that different functions are possible simultaneously for each FTK. After a power failure, the link is restored by a new signal from the FTK or with the next status message after 15 minutes. An additionally set RV time is not taken into account. Function with wireless smoke detectors FRW or water sensors according to the operating instructions. The LED below the upper rotary switch accompanies the teaching-in process according to the operating instructions and indicates control commands by briefly flashing during operation.