ELTAKO Multifunction Time Relay 230V+UC, 10 Func., 1 N/O Contact non-isolated 16 – 23100001

1 NO contact, non-floating 16A/250V AC, 230V-LED lamps up to 200W, incandescent lamps 2300W*. Stand-by loss only 0.5 watt. Modular device for mounting on DIN-EN 60715 TH35 mounting rail. 1 module unit = 18mm wide, 58mm deep. Zero-crossing switching to protect contacts and lamps. State-of-the-art hybrid technology combines the advantages of wear-free electronic control with the high performance of special relays. Control voltage 230V and additionally galvanically isolated universal control voltage 8..230V UC. Supply and switching voltage 230V. Very low switching noise. Times adjustable between 0.1 seconds and 40 hours. Functions F: RV = Off delay. AV = On delay. TI = Clock generator starting with pulse. TP = Clock generator starting with pause. IA = Pulse-controlled on delay. EW = Switch-on wiper. AW = Switch-off wiper. ARV = On and off delay. ON = Continuous ON. OFF = Continuous OFF. The LED below the upper rotary switch indicates the contact position during the time sequence. It flashes as long as the normally open contact is open and glows continuously as long as it is closed. The time base T is set with the middle detented rotary switch T. The basic values available are 0.1 seconds, 0.5 seconds, 2 seconds, 5 seconds, 1 minute, 2 minutes, 5 minutes, 1 hour, 2 hours, and 4 hours. The total time results from the time base multiplied by the multiplier. The multiplier xT is set with the upper detented rotary switch xT and is between 1 and 10. This allows times between 0.1 seconds (time base 0.1 seconds and multiplier 1) and 40 hours (time base 4 hours and multiplier 10) to be set. * The maximum load can be used from a delay or cycle time of 5 minutes. For shorter times, the maximum load is reduced as follows: Up to 2 seconds to 15%, up to 2 minutes to 30%, up to 5 minutes to 60%.