ELTAKO Multifunction Time Relay, 18 functions, 1 N/C contact, floating, 10A/250VAC – 23001004

1 NO contact, 10A/250V AC, for 230V LED lamps up to 200W, incandescent lamps 2000W*. Stand-by loss only 0.05-0.5 watts. Series installation device for mounting on DIN-EN 60715 TH35 rail. 1 module = 18mm wide, 58mm deep. With the patented ELTAKO Duplex technology (DX), the normally potential-free contacts can switch at zero crossing when switching 230V AC 50Hz, thus drastically reducing wear. Simply connect the neutral conductor to terminal (N) and L to 15(L). This results in an additional stand-by loss of only 0.1 watt. Universal control voltage 12..230V UC. Supply voltage same as control voltage. Both the function and the times are entered by pressing a button and digitally displayed on an LC display. Only two buttons need to be operated for this. When setting the time, all values can be entered within the preselected time frames (0.1-9.9 or 1-99 seconds, minutes or hours). The longest time is 99 hours. 600 time settings are possible. The entered time(s) is (are) continuously displayed digitally. Due to the use of a bistable relay, there is no coil power loss and no heating in the switched-on state. After installation, wait for the automatic short synchronization before connecting the switched consumer to the mains. Functions: RV = release delay. AV = attract delay. AV+ = additive attract delay. TI = clock generator starting with pulse. TP = clock generator starting with pause. IA = pulse-controlled attract delay (e.g. automatic door opener). IF = pulse shaper. EW = turn-on wipe. AW = turn-off wipe. EAW = turn-on and turn-off wipe. For functions TI, TP, IA, EAW, ARV and ARV+, a different second time can be entered, also with a different time frame. Setting times and functions: By pressing the MODE button, the LCD element to be changed is selected. The element currently in access flashes. By pressing the SET button, the element in access is changed. This can be the function, the time frame, time T1 or time T2 (only for TI, TP, IA, EAW, ARV and ARV+). Each entry is terminated with the MODE button. After setting the time with MODE, no element flashes anymore – the time relay is ready for operation. With the next press of the MODE button, the entry cycle starts again from the beginning, all set parameters remain, unless they are changed with SET. 25 seconds after the last operation and if an element is still flashing, the entry cycle is automatically terminated and previous changes expire. Display functions of the LC display: If the functions ON or OFF have been selected, no time is displayed, but only ON or OFF and the contact symbol in the correct position are shown. For all other functions, the set time(s), the function abbreviation and the contact symbol in the correct open or closed position are shown. During the time countdown, the remaining time flashes and is displayed. Safety in case of power failure: The set parameters are stored in an EEPROM and are therefore immediately available again after a power failure. * The maximum load can be used from a delay or cycle time of 5 minutes. For shorter times, the maximum load is reduced as follows: Up to 2 seconds to 15%, up to 2 minutes to 30%, up to 5 minutes to 60%.