ELTAKO Wireless Impulse Switch Relay 230V. 1 NO contact not potential-free 10A/250VA – 30100030

1 NO contact, not floating, 10A/250V AC, 230V LED lamps up to 400W, incandescent lamps 2000 watts. Re-triggering delay with switch-off warning and push-button continuous light can be switched on. Encrypted wireless, bidirectional wireless and repeater function can be switched on. Stand-by loss only 0.8 watts. For flush mounting. 45mm long, 45mm wide, 33mm deep. Supply, switching and control voltage locally 230V. If the supply voltage fails, the switching state is maintained. When the supply voltage returns, it switches off in a defined manner. After installation, wait for the automatic short synchronization before connecting the switched consumer to the mains. In addition to the wireless control input via an internal antenna, this wireless actuator can also be controlled locally with a conventional 230V control push-button possibly mounted in front of it. A glow lamp current is not permitted. Encrypted sensors can be taught in. Bidirectional wireless and/or a repeater function can be switched on. Every change of state as well as received central control telegrams are then confirmed with a wireless telegram. This wireless telegram can be taught into other actuators, controllers and universal displays. Scene control: With one of the four control signals of a push-button with a double rocker taught in as a scene push-button, several FSR61s can be switched on or off to form a scene. With the upper rotary switch, up to 35 wireless push-buttons are assigned in the LRN position, including one or more central control push-buttons. In addition, wireless window/door contacts with the function NO contact or NC contact when the window is open, wireless outdoor brightness sensors FAH and wireless motion detectors FBH. The desired function of this impulse switching relay is then selected: ER = switching relay. ESV = impulse switch. Optionally with re-triggering delay, then +push-button continuous light = ESV with push-button continuous light, +switch-off warning = ESV with switch-off warning, +push-button continuous light and switch-off warning = ESV with push-button continuous light and switch-off warning. If push-button continuous light is switched on, pressing for longer than 1 second can set it to continuous light, which switches off automatically after 2 hours or can be switched off by pressing. If the switch-off warning is switched on, the lighting flashes approx. 30 seconds before the time expires and a total of 3 times at increasingly shorter intervals. If switch-off warning and push-button continuous light are switched on, the switch-off warning only occurs after the continuous light has switched off automatically. With the lower rotary switch, the re-triggering delay can be set from 2 to 120 minutes in the ESV function. In the infinite position, normal impulse switch function ES without re-triggering delay, without push-button continuous light and without switch-off warning. In the ER = switching relay position of the other rotary switch, this second rotary switch fulfills a safety and power-saving function in settings other than infinite: If the switch-off command is not recognized, e.g., due to a sticking or too hastily operated push-button, the relay switches off automatically after the adjustable time between 2 and 120 seconds has elapsed. If an FTK has been taught in, this time function is switched off. Twilight switch with taught-in wireless outdoor brightness sensor FAH and motion detection with taught-in wireless motion detector FBH according to the operating instructions. The LED accompanies the teaching-in process according to the operating instructions and indicates wireless control commands by briefly flashing during operation.