ELTAKO Wireless Actuator Multifunction Time Relay 230V. 1 NO contact potential-free 10A/250V AC, – 30100230

1 NO contact, potential-free 10A/250V AC, 230V LED lamps up to 400W, incandescent lamps 2000 Watts*. Encrypted wireless, bidirectional wireless and repeater function switchable. Stand-by loss only 0.8 Watt. For flush mounting. 45mm long, 45mm wide, 33mm deep. Supply and control voltage locally 230V. In case of power failure, the switching state is maintained. When the power supply returns, it is switched off in a defined manner. This wireless actuator features the most modern hybrid technology developed by us: We have combined the wear-free reception and evaluation electronics with a bistable relay. As a result, there is no coil power loss and no heating in the switched-on state. After installation, wait for the automatic short synchronization before connecting the switched load to the mains. In addition to the wireless control input via an internal antenna, this wireless actuator can also be controlled locally with a conventional control button that may be mounted in front of it. A glow lamp current is not permitted. Encrypted sensors can be taught-in. Bidirectional wireless and/or a repeater function can be switched on. Every change of state as well as received central control telegrams are confirmed with a wireless telegram. This wireless telegram can be taught into other actuators, controllers and universal displays. With the upper rotary switch, up to 35 wireless pushbuttons can be assigned in the LRN position, including one or more central control pushbuttons. Also, wireless window-door contacts (FTK) with the function of normally open or normally closed when the window is open. If a directional button is taught in, a function (e.g. TI) can be started with the upper button (START) and stopped with the lower button (STOP). The desired function of this wireless actuator is then selected. The changeover is visualized by the LED flashing. RV = release delay. AV = activation delay. TI = timer starting with pulse. IA = pulse-controlled activation delay. EW = ON-wipe. With the lower rotary switch, the time can be set from 0.5 seconds to 60 minutes. The LED accompanies the teach-in process according to the operating instructions and indicates wireless control commands by briefly flashing during operation. * The maximum load can be used from a delay or cycle time of 5 minutes. For shorter times, the maximum load is reduced as follows: Up to 2 minutes to 30%, up to 5 minutes to 60%.