Universal dimmer switch, power MOSFET up to 300W – 21100807

Universal dimmer switch for lamps up to 300W, depending on ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps additionally depend on the lamp electronics and the dimming type. Zero-crossing switching with soft-on and soft-off for lamp protection. Control, supply, and switching voltage 230V. The integrated timer has up to 10 program memory slots. With date and automatic summer/winter time changeover. Power reserve without battery approx. 5 days. Each memory slot can be assigned either with the Astro function (automatic switching according to sunrise or sunset), or one of the 9 functions (On, Off, On with dimming value in %, On with memory value, light alarm, snooze circuit, On with residual brightness, Off with residual brightness, TI). In the event of a power failure, the switching position and brightness level are saved and, if applicable, switched on again when the supply voltage returns. Automatic electronic overload protection and overtemperature shutdown. In the delivery state, the operating mode Auto is active. Short control commands at the local control input switch on/off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the dimming direction. Central control is active, with priority, and the motion detector switches on with the memory value. To change or configure the operating mode, a connection to the ELTAKO Connect app must be established. Connect dimmer switch with the app: Press the button on the front for 6 seconds, the blue LED flashes. Now the connection with the app can be established (delivery state PIN123123). The flashing of the blue LED signals coupling readiness, which ends automatically after 3 minutes, but can also be manually terminated by pressing a button >6 seconds. Scan the QR code on the operating instructions, the app guides you through the learning process. After the connection to the app has been established, the blue LED lights up continuously. If the connection is not disconnected via the app, it will be automatically disconnected after 20 minutes without interaction with the app. After disconnecting the connection via the app, the dimmer switch again signals its readiness for pairing and the blue LED flashes. Change PIN: The PIN for the Bluetooth connection can be changed in the app, under the entry Device PIN. Bluetooth reset (delete possibly changed PIN): Tap the button on the front 8 times briefly. The Auto dimming value setting allows dimming of all lamp types. Leading edge LC1-LC3 are comfort settings with different dimming curves for dimmable 230 V LED lamps, which cannot be dimmed down far enough in Auto mode due to their design and therefore have to be forced into leading edge mode. Trailing edge LC4-LC6 are comfort settings with different dimming curves for dimmable 230V LED lamps, which cannot be dimmed down far enough in Auto mode. In the leading edge and trailing edge settings, no inductive (wound) transformers may be used.