Blister Pack Switching – 30000037

Blister pack consisting of an F2T55E wireless push-button and an FSR61-230V wireless impulse switching relay actuator. Smart Home sensor and Smart Home actuator. F2T55E: Pure white glossy wireless push-button for single mounting 80x80x15mm or mounting in the E-Design55 switch system. Generates the energy for radio telegrams itself when a button is pressed, therefore no connecting cable and no standby loss. Wireless push-buttons with one rocker can send two evaluable signals: press rocker top and press rocker bottom. The mounting plate can be screwed over a device box with a screw spacing of 60mm or onto a flat surface. With the enclosed adhesive film, the wireless push-button can be glued to the wall, on glass or on furniture. FSR61-230V: Wireless impulse switching relay actuator, 1 normally open contact, potential-free 10A/250V AC, incandescent lamps 2000 Watts, switch-off delay with early warning and push-button continuous light switchable. Encrypted wireless, bidirectional wireless and repeater function switchable. Standby loss only 0.8 Watts. For flush mounting. 45mm long, 45mm wide, 33mm deep. Local supply and control voltage 230V. In the event of a power supply failure, the switching state is retained. When the power supply returns, it switches off in a defined manner. After installation, wait for the automatic short synchronization before connecting the switched consumer to the mains. In addition to the wireless control input via an internal antenna, this wireless actuator can also be controlled locally with a conventional control button that may be mounted in front of it. A glow lamp current is not permitted.