Analog adjustable time-delay relay, 1 changeover contact 10A – 23001202

Delay on break, 1 N/O contact, potential-free 10A/250V AC. 230V LED lamps up to 200W, incandescent lamps 2000W*. Stand-by loss only 0.02-0.4 watts. Modular devices for mounting on DIN-EN 60715 TH35 mounting rail. 1 module unit = 18mm wide, 58mm deep. With the patented ELTAKO Duplex technology (DX), the contacts, which are usually potential-free, can still switch at zero crossing when switching 230V AC 50Hz, thereby drastically reducing wear. To do this, simply connect the N-conductor to terminal (N) and L to 15(L). This results in an additional stand-by loss of only 0.1 watts. Universal control voltage 12..230V UC. Supply voltage same as control voltage. Time range 0.1 seconds to 40 hours. Due to the use of a bistable relay, there is no coil power loss and no heating in the switched-on state. After installation, wait for the automatic short synchronization before connecting the switched load to the mains. The LED under the large rotary switch indicates the contact position during the time sequence. It is off as long as the normally open contact 15-18 is open (15-16 closed) and glows continuously as long as the normally open contact 15-18 is closed (15-16 open). The time base T is set with the detented rotary switch T. The basic values available are 0.1 second, 0.5 seconds, 2 seconds, 5 seconds, 1 minute, 2 minutes, 5 minutes, 1 hour, 2 hours, and 4 hours. The total time is calculated by multiplying the time base by the multiplier. The multiplier xT is set with the detented rotary switch xT and is between 1 and 10. This allows times between 0.1 seconds (time base 0.1 seconds and multiplier 1) and 40 hours (time base 4 hours and multiplier 10) to be set. * The maximum load can be used for a delay or cycle time of 5 minutes or more. For shorter times, the maximum load is reduced as follows: Up to 2 seconds to 15%, up to 2 minutes to 30%, up to 5 minutes to 60%.