Multifunction Universal Dimmer Switch, Power MOSFET up to 400W – 61100903

Universal dimming switch. Power MOSFET up to 400W. Automatic lamp detection. Standby loss only 0.1 Watt. Minimum brightness adjustable. With nursery and snooze circuit. For flush mounting. 45mm long, 45mm wide, 18mm deep. Universal dimming switch for lamps up to 400W, depending on ventilation conditions. Dimmable 230V LED lamps and dimmable energy-saving lamps also depend on the lamp electronics. Zero-crossing switching with soft-on and soft-off for lamp protection. Universal control voltage 8..230V UC, galvanically isolated from the supply and switching voltage 230V. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the dimming direction. The set brightness level remains stored in the memory functions when switched off. In the on-max functions, the device is always switched on with the maximum brightness level. In the event of a power failure, the switch position and the brightness level are stored and, if necessary, switched on when the supply voltage returns. Automatic electronic overload protection and overtemperature shutdown. With the upper %Lampe rotary switch, the minimum brightness (fully dimmed) can be set, e.g. for dimmable energy-saving lamps. Automatic operation allows dimming of all lamp types. With the lower function rotary switch, you can select between five automatic operating functions: memory, memory+soft on, on max, on max+soft on and ESV+soft on. +ESL is a comfort setting for energy-saving lamps that, due to their design, must be switched on with an increased voltage so that they can be switched on again when dimmed, even when cold. -ESL is a comfort setting for energy-saving lamps that, due to their design, cannot be switched on again when dimmed. Therefore, memory is switched off in this position. In the +ESL and –ESL positions, no inductive (wound) transformers may be used. In addition, the maximum number of dimmable energy-saving lamps may be lower due to the design than in automatic operation. ESV function setting like memory+soft on with setting a fallback delay on the %Lampe rotary switch up to 90 minutes if not manually switched off. At the end, switch-off warning by dimming down within 1 minute. With nursery circuit: When switched on with a longer button press, the light switches on after approx. 1 second with the lowest brightness and, as long as the button is pressed, slowly dims up without changing the last stored brightness level. With snooze circuit: By a double pulse, the lighting is dimmed from the current dimming position to the minimum brightness and switched off. The max. dimming time of 60 minutes depends on the current dimming position and the set minimum brightness and can therefore be shortened accordingly. By briefly pressing a button, the light can be switched off at any time during the dimming process. A long press during the dimming process dims up and ends the snooze circuit. L-loads (inductive loads, e.g. wound transformers) and C-loads (capacitive loads, e.g. electronic transformers) must not be mixed. R-loads (resistive loads, e.g. 230V incandescent and halogen lamps) can be added as required.