K2 Mounting Kits Flat Roof D-Dome 6.10
(5 products)The K2 mounting kits D-Dome 6.10 mount modules on flat roofs in an east-west orientation with a 10° tilt. The modules are installed in double rows back-to-back – this results in very high area utilization and a more even daily profile with yield in the morning and evening. The basis are pre-assembled Base Sets with Peak and Windbreaker. Available for 4 to 12 modules. Ballast is not included in the set.
East-West with 10 degrees
Two rows of modules each are mounted back-to-back and face east and west. Because little space is needed between the double rows, significantly more modules fit on the same roof area. The shallow angle of 10° keeps the wind attack surface small and distributes the yield over the day.
What is included
Pre-assembled Base Sets with building protection mats, Peak and Windbreaker, module clamps, connecting elements, and potential equalization TerraGrif. Ballast (paving slabs or gravel) must be determined on a project-specific basis and is not included in the set.
Why always even numbers of modules?
The modules are mounted in pairs back-to-back. Therefore, the sets are available for 4, 6, 8, 10, and 12 modules.
Is ballast included in the set?
No. The required ballasting depends on the location, building height, and roof structure and must be provided by the customer.
Which modules are the sets designed for?
Standard framed modules with a frame height of 30–42 mm.
Does the roof need to be statically checked?
Yes. The design is based on wind load zone 2 and storey height 3. Roof waterproofing and permissible load must be checked on a project-specific basis.
- Most relevant
- Best selling
- Alphabetically, A-Z
- Alphabetically, Z-A
- Price, low to high
- Price, high to low
- Date, old to new
- Date, new to old
K2 SYSTEMS Flat Roof Mounting Kit D-Dome 6.10 – 4 Solar Modules
Regular priceRegular price € 261,26 inkl. USt.
€ 217,72 exkl. USt.Unit price
